Symptom

Cause / check procedure

Solution method

Unable to enter control software

The program's data is destroyed

Re install the program; to confirm the system without virus

Other programs can't run

Re install WINDOWS system

There is an error in the simulation run

Check G code file error

Correct branch; correct error code

DXF graphics file is wrong

Fixed crossing point; remove coincidence line segment

X, Y axis of a shaft without action

Driver fault

1 point to move the shaft button, while observing the axis drive indicator light is working;

2 observation of the shaft connector and the other connector after the replacement of normal shaft shaft if there is action.

Head&motor failed

The connector is not connected

Check the connector is reliable

Lost step

MOTOR PHASE

check the wiring

Driver fault

Change driver

The card is not correct or IO card fault

To change the card or card

Motor related parameters are modified

Parameters to be modified

Operating instructions no response

Emergency stop button is not reset

Reset emergency stop button

Loose, break point and element damage on electrical circuit

To re connect; replace damaged components.

Virus effect

Re install the program